Getting Your Parts And Supplies To Make Solar Panels

I’ve been putting together a set up to create solar panels. I am going to use these panels when I go camping to power up things that I’d normally have use the battery on my truck. If you own an RV or camper you may do the same. I’ve determined to start out with a seemingly easier project than going all out and trying to power up the house. Don’t get me wrong, it’s on the list, but you have to walk before you can run. An exponent of mine has a large shed at the back of his property and we tend to were thinking of powering that up with solar panels rather than running a separate power line across the property. No matter you choose to try and do keep it easy and simple at the start. Since I’ve got the fundamental plan, currently it is time to induce the cells, the wood, the Plexiglas, and also the tools.

I’ve determined that I’m going to make 3 solar panels. I conducted a look on eBay and located a good bid for solar cells that value concerning regarding $1.thirty a piece. I’ve debated using white or black Plexiglas because the frame and backing for my solar panels. However, since this project isn’t going to weather the weather for years on finish I assume I will depart with wood frames. At the hardware store I will get precut sheets of quarter inch plywood for regarding five dollars each. A box of stainless-steel screws for regarding 5 dollars.

I’ve got all of the tools that I will want:

* a drill
* a saw
* a solder iron
* a multimeter

I will have to buy some solder, and clear adhesive caulk as a sealant. I additionally want to induce some black UV protected paint, some serious gauge wire and my Plexiglas cover. In all, I anticipate, that every of the three panels will value about $thirty five dollars.

I am designing to make solar panels that may fit inside a 16″x24″ container for simple storage and portability. My set up concerns three solar panels with twelve, 3×6 solar cells each. The cells and therefore the panels will all be wired in series. This could provide me an eighteen volt system, that should be enough to charge a 12 volt deep cycle battery. The battery can be the most expensive half of the entire build, costing concerning $150 dollars. In this arrange I am not going to use multiple batteries since it can not be necessary to power up solely a few electrical accessories that I would take with me camping. If you were visiting power up your RV or camper you might have to think about adding several batteries to provide both the required amps and watts for your appliances.

The following half of the project is that the building phase. Keeping in mind that you mostly want to measure twice and cut once. I’ll be cutting out my backboard and fitting it to my frame. Once that the plans demand sizing up the Plexiglas and fitting it to the frame. Once I’m certain that everything is going to fit nice and cosy into my containers then I will paint the frames and start soldering the cells together. All in all it ought to take me the better half of each day, in all probability the weekend, to urge everything done.

Go Earth Energy strongly recommends the Inexperienced DIY Energy Solar and Wind Energy Guide. You’ll simply create a solar panel or a wind generator to power your house, garage, cabin or well…just regarding anything. Try Go Earth Energy for diy energy reviews, product, comes and information.

To save energy at home is to indirectly save money and heavily reduce home expenditures. Read more at my site:self made solar energy for more information about self made solar energy at home. Learn more about saving energy and acquiring energy efficient homes: self made solar energy review.